Classy CNC tube rings with elegant design and uncompromising quality
A beautiful telescope should be attached to the mount with the finest tube ring. Here, a beautiful appearance is as important as good technical properties. The CNC tube rings meet these requirements.
The tube is attached to the mount or the dovetail via a largely dimensioned support surface with 50 mm width.
The rings have identical support surfaces on top which allow attaching dovetail clamps or another dovetail bar.
3 M6 thread (female) on top and bottom, one centered, two with 15 mm distance to the middle
The rings can be folded open, thus the telescope can be removed from them within seconds.
A thin layer of felt was applied to the inner side of the rings. This prevents from scratches. Nevertheless, the telescope tube is clamped very well in the rings and cannot become misaligned. This is important if a guiding scope is attached to the rings.
- Set of 2x aluminium CNC tube rings
Stable, easily swivelling open metal clamps for an optimal connection between telescope and mount